Oxygen Sensor Bank 1 Sensor 1 - Removal

Warning - General - Stabilise Motorcycle - including DO NOT support on non integral parts

warning
Make sure the motorcycle is stabilised and adequately supported.Do not support the motorcycle on any ancillary component, the exhaust system or any other non structural parts of the motorcycle frame.A correctly supported motorcycle will help prevent it from falling.Failure to follow the advice above could result in serious injury or death.

Caution - Hot Exhaust

caution
If the engine has recently been running, the exhaust components can be hot.Always allow the hot components to cool before working on the exhaust system.Contact with the hot components could cause minor to moderate burns to exposed skin.

Perform the following operations

Perform the following operations:

Oxygen Sensor Bank 1 Sensor 1 - Removal - LG1; LGX; LL1

  1. Disconnect the oxygen sensor from the main harness and remove the rubber bands. Note the position of the rubber bands for installation.
    2. O2 Sensor Connection LG1 (ckys_1)

    1. Oxygen sensor electrical connector

    2. Rubber band

    3. Coolant tee piece

  2. Remove the oxygen sensor bank 1 sensor 1 from the exhaust header.
    3. O2 Sensor LG1 (ckyt)

    1. Oxygen sensor