Oxygen Sensor Bank 1 Sensor 1 - Installation

Warning - General - Stabilise Motorcycle - including DO NOT support on non integral parts

warning
Make sure the motorcycle is stabilised and adequately supported.Do not support the motorcycle on any ancillary component, the exhaust system or any other non structural parts of the motorcycle frame.A correctly supported motorcycle will help prevent it from falling.Failure to follow the advice above could result in serious injury or death.

Note to be used in service manual with stabilise warning

notice
Renew locking devices where specified, refer to Fixings.Before tightening a fixing using a crow foot spanner adapter, refer to Use of Crow Foot Spanner Adapters with Torque Wrenches.Observe all torque wrench tightening procedures, refer to Tightening Procedures.

Oxygen Sensor Bank 1 Sensor 1 - Installation - LG1; LGX; LL1

  1. Insert the oxygen sensor bank 1 sensor 1 into the exhaust header. Tighten to 25 Nm.
    2. O2 Bank 1 sensor 1_TP0518

    1. Oxygen sensor bank sensor 1

  2. Reroute the oxygen sensor harness as noted during removal and reconnect to the main harness.
  3. Secure the oxygen harness to the coolant hose with two rubber bands.
    4. O2 Sensor Connection LG1 (ckys_1)

    1. Oxygen sensor electrical connector

    2. Rubber band

    3. Coolant tee piece

Perform the following operations

Perform the following operations: