Clutch Cover - Removal

Warning - General - Stabilise Motorcycle - including DO NOT support on non integral parts

warning
Make sure the motorcycle is stabilised and adequately supported.Do not support the motorcycle on any ancillary component, the exhaust system or any other non structural parts of the motorcycle frame.A correctly supported motorcycle will help prevent it from falling.Failure to follow the advice above could result in serious injury or death.

Perform the following operations

Perform the following operations:

Seat - Remove L Series

Battery - Remove L Series

  1. Release the clutch cable from the actuating arm (see Clutch Cable - Removal).
  2. Place an oil catch tray beneath the clutch cover to collect any oil that may spill out during removal.
  3. Release the fixings that attach the clutch cover to the crankcases. Note the position of the copper washer for installation.
    4. Clutch cover removal L0330

    1. Clutch cover

    2. Copper washer position

  4. Carefully withdraw the cover.
  5. Remove the gasket and clean the surfaces of the crankcase and the clutch cover using a lint free cloth.