Clutch Cover - Installation

Warning - General - Stabilise Motorcycle Including locking devices

Warning - General - Stabilise Motorcycle - including DO NOT support on non integral parts

warning
Make sure the motorcycle is stabilised and adequately supported.Do not support the motorcycle on any ancillary component, the exhaust system or any other non structural parts of the motorcycle frame.A correctly supported motorcycle will help prevent it from falling.Failure to follow the advice above could result in serious injury or death.

Note to be used in service manual with stabilise warning

notice
Renew locking devices where specified, refer to Fixings.Before tightening a fixing using a crow foot spanner adapter, refer to Use of Crow Foot Spanner Adapters with Torque Wrenches.Observe all torque wrench tightening procedures, refer to Tightening Procedures.
notice
The pull-rod should be free to move in and out, and also it should be free to turn.
  1. Incorporating a new clutch cover gasket, position the clutch cover to the crankcase.
  2. Install the clutch cover fixings and the copper washer in the position noted during removal.
  3. Tighten the clutch cover fixings to 8 Nm in the sequence shown below.
  4. Re-tighten the fixings one and two to 8 Nm.
    5. Clutch cover install L0330_1

    Clutch Cover Fixings Tightening Sequence

  5. Fit the clutch cable to the actuating arm (see Clutch Cable - Installation).
  6. Set the clutch adjustment (see Clutch Cable - Installation).

Perform the following operations

Perform the following operations:

Battery - Install L Series

Seat - Install L Series