Front Sprocket Cover - Installation

Warning - General - Stabilise Motorcycle

warning
Make sure the motorcycle is stabilised and adequately supported.Do not support the motorcycle on any ancillary component, the exhaust system or any other non structural parts of the motorcycle frame.A correctly supported motorcycle will help prevent it from falling.An unstable motorcycle may fall resulting in motorcycle damage, serious injury or death.

Caution - Drive Chain trapped fingers

caution
If the rear wheel is rotated, fingers, hands or loose clothing could become trapped as the drive chain rotates on the sprockets, and cause a crushing injury to the fingers, hands or other parts of your body.To prevent injury, never place fingers, hands or loose clothing near the drive chain or sprockets.

Front Sprocket Cover Install LG1; LG2; LGX; LH2

  1. Fit the sprocket cover, ensuring that the breather hoses and harnesses are routed as noted for removal.
  2. Fit the sprocket cover fixings and evenly tighten to 9 Nm.
  3. Position the evaporative drain hose as noted during removal.
    4. Sprocket Cover (ckva_1)

    1. Front sprocket cover

    2. Fixings

    3. Breather hoses and harnesses

    4. Evaporative canister drain hose

Perform the following operations

Perform the following operations: