Crankcase Right Hand Cover - Installation

Warning - General - Stabilise Motorcycle Including locking devices

Warning - General - Stabilise Motorcycle - including DO NOT support on non integral parts

warning
Make sure the motorcycle is stabilised and adequately supported.Do not support the motorcycle on any ancillary component, the exhaust system or any other non structural parts of the motorcycle frame.A correctly supported motorcycle will help prevent it from falling.Failure to follow the advice above could result in serious injury or death.

Note to be used in service manual with stabilise warning

notice
Renew locking devices where specified, refer to Fixings.Before tightening a fixing using a crow foot spanner adapter, refer to Use of Crow Foot Spanner Adapters with Torque Wrenches.Observe all torque wrench tightening procedures, refer to Tightening Procedures.
  1. Fit a new gasket to the crankcase right hand cover.
    2. notice
    Make sure the copper washer is fitted between the crankcase cover and the head of fixing number one.
  2. Fit the crankcase right hand cover with the copper washer in the position noted during removal.
  3. Tighten its fixings to 8 Nm in the sequence shown below.
  4. Re-tighten the fixings one and two to 8 Nm.
    5. rh crank cover_seq (ckuw)

    Crankcase Right Hand Cover Fixings Tightening Sequence