Engine Breather Cover - Removal

Warning - General - Stabilise Motorcycle

warning
Make sure the motorcycle is stabilised and adequately supported.Do not support the motorcycle on any ancillary component, the exhaust system or any other non structural parts of the motorcycle frame.A correctly supported motorcycle will help prevent it from falling.An unstable motorcycle may fall resulting in motorcycle damage, serious injury or death.

Perform the following operations

Perform the following operations:

Seat - Remove L Series

Battery - Remove L Series

Fuel Tank - Remove L Series

Side Panels - Removal LG1; LG2; LGX; LH2

Airbox - Remove L Series

Airbox - Remove L Series

Throttle Body - Remove L Series

Inlet Manifold - Removal - LG1; LG2; LGX; LH2; LL1

Engine Breather Cover Removal - LG1; LG2; LGX; LH2; LL1

  1. Release the hose clip and detach the engine breather hose from the engine breather cover.
    2. notice
    Note the positions of the two harness brackets and the inlet manifold bracket mounted to the engine breather cover for installation.
  2. Detach the harness from the two brackets mounted to the breather cover.
  3. Release the six fixings and remove the engine breather cover.
    4. breather cover (ckuv_1)

    1. Engine breather cover

    2. Fixings

    3. Harness bracket

    4. Harness bracket

    5. Inlet manifold bracket

  4. Discard the gasket.