Airbox - Installation

Warning - General - Stabilise Motorcycle

warning
Make sure the motorcycle is stabilised and adequately supported.A correctly supported motorcycle will help prevent it from falling.An unstable motorcycle may fall, causing injury to the operator or damage to the motorcycle.
  1. Make sure the blank is fitted to the underside of the airbox and the clip is positioned towards the centreline.
    2. Airbox Spigot LG1; LGX

    1. Airbox

    2. Blank

    3. Clip

  2. Make sure the rubber seal and clamp are fitted to the airbox as noted during removal.
  3. Position the airbox to the motorcycle and refit the secondary air injection hose and breather hose to the airbox.
  4. Push the airbox forwards on to the throttle body and align the two rear fixing holes.
  5. Install the two rear fixings and flanged sleeves and tighten to 6 Nm.
    6. Airbox Rear Fixing_1 (ckvq)

    1. Airbox

    2. Fixings

  6. Tighten the airbox clamp to 1.5 Nm.
    7. Airbox Clamp_1 (ckvn)

    1. Airbox

    2. Clamp

Perform the following operations

Perform the following operations:

Fuel Tank - Install L Series

Battery - Install L Series

Seat - Install L Series