Headlights - Installation

Warning - General - Stabilise Motorcycle

warning
Make sure the motorcycle is stabilised and adequately supported.A correctly supported motorcycle will help prevent it from falling.An unstable motorcycle may fall, causing injury to the operator or damage to the motorcycle.

Headlight Install LG1; LGX

  1. If required, ensure the rubber grommets are fitted to the headlight brackets. Position the brackets to the headlight and secure with two fixings and washers and tighten to 3 Nm.
    2. Headlight Connection_2 (ckug)

    1. Headlight

    2. Headlight bracket, left hand side

    3. Headlight bracket, right hand side

    4. Fixings

  2. Reconnect the electrical connector and position the harness as noted during removal. Install a new cable tie to secure the harness.
    3. Headlight Routing_1 (ckuk)

    1. Headlight assembly rear cover

    2. Harness

    3. Cable tie

  3. Install the headlight assembly rear cover to the headlight and secure with three fixings. Tighten the fixings to 3 Nm.
    4. Headlight Connection_1 (ckuh)

    1. Headlight assembly rear cover

    2. Electrical connector

    3. Fixings

  4. Position the headlight to the lower yoke and install the pivot bolt and lock nut. Adjust the headlight to the correct height and tighten the lock nut to 26 Nm.
    5. headlight fixing_1 (ckui)

    1. Headlight Assembly

    2. Pivot bolt

Perform the following operations

Perform the following operations:

Battery - Install L Series

Seat - Install L Series