Rear Wheel Bearing - Installation
note
Refer to the chart below for the correct tool and tool face when inserting bearings. Bearings are inserted by means of a draw-bolt acting on the insertion tool. A support tool is located on the opposite side of the wheel to the insertion tool and as the bolt is tightened, the bearing is drawn into the wheel. Insert bearings with the marked or shielded side facing outwards and always fit a new bearing circlip and seals.
Bearing insertion tool | Support tool | |
|---|---|---|
Left bearing | service tool T3880070 Small face to bearing | service tool T3880065 Large face to wheel |
Right bearing | service tool T3880070 Small face to bearing | service tool T3880065 Large face to wheel |
- Fit the wheel bearings and centre sleeve using the method described above.
- Fit a new circlip.
- Lubricate and fit new seals to the rear wheel. Lubricate the seal’s knife-edge with grease to NLGI 2 specification.
T3880070 - Bearing Installer |
Perform the following operations
Perform the following operations: