Side Panels - Removal

Warning - General - Stabilise Motorcycle

warning
Make sure the motorcycle is stabilised and adequately supported.A correctly supported motorcycle will help prevent it from falling.An unstable motorcycle may fall, causing injury to the operator or damage to the motorcycle.

Perform the following operations

Perform the following operations:

Seat - Remove L Series

Battery - Remove L Series

Side Panels Remove LG1; LGX

  1. Remove the central fixings and lock nuts. Discard the lock nuts.
  2. Remove the rear fixings and washers.
    3. SidePanelRH_1 (ckvm)

    1. Central fixing

    2. Lock nut

    3. Side panel

    4. Rear fixing

    5. Washer

  3. Ease the front of the side panel away from the motorcycle, releasing the front clip and the spigot from the rubber grommet. Note their position for installation. Raise the side panel to release the locating slot from the frame.
  4. On the left hand side panel, rotate the seat lock cable end 180 degrees and release it from the seat lock assembly and bracket, noting the position of the cable in the bracket locating feature for installation.
    5. SidePanel LH (LH side panel LG1)

    1. Seat lock cable end

    2. Spigot

    3. Side panel

    4. Clip

    5. Locating slot