Side Panels - Installation

Warning - General - Stabilise Motorcycle

warning
Make sure the motorcycle is stabilised and adequately supported.A correctly supported motorcycle will help prevent it from falling.An unstable motorcycle may fall, causing injury to the operator or damage to the motorcycle.

Side panels Install LG1; LGX

  1. Ensure the rubber grommets and plastic clips are in place as noted during removal.
  2. For the left hand side panel, install the seat lock cable to the seat lock assembly and bracket. Make sure the cable is located in the bracket locating feature as noted during removal.
  3. Align the side panel locating slot to the frame locating tang. Press the spigots into the rubber grommets and make sure the plastic clips are locked in place.
    4. SidePanel LH (LH side panel LG1)

    1. Seat lock cable end

    2. Spigot

    3. Side panel

    4. Clip

    5. Locating slot

  4. Install the central fixings with new lock nuts. Install the rear fixings and washers. Tighten the fixings to 3 Nm.
SidePanelRH_1 (ckvm)

  1. Central fixing

  2. Lock nut

  3. Side panel

  4. Rear fixing

  5. Washer

Perform the following operations

Perform the following operations:

Battery - Install L Series

Seat - Install L Series