Rear Light - Installation

Warning - General - Stabilise Motorcycle

warning
Make sure the motorcycle is stabilised and adequately supported.A correctly supported motorcycle will help prevent it from falling.An unstable motorcycle may fall, causing injury to the operator or damage to the motorcycle.

Rear Light Install LG1; LGX

  1. Fit the rear light to the rear undertray assembly with two fixings and tighten to 3 Nm.
    2. Rear Light (cktt)

    1. Rear light

    2. Fixings

    3. Rear undertray assembly

  2. Install the rear undertray and rear light assembly to the motorcycle, aligning the two locating slots to the rubber grommets. Secure with two rear fixings and two scrivets and tighten the fixings to 3 Nm.
    3. Rear Light (ckts)

    1. Rear light

    2. Fixings

    3. Scrivets

    4. Rear undertray assembly

  3. Reconnect the rear light electrical connector to the harness.
    4. Rear Light Connection_1 (ckwc)

    1. Rear light electrical connector

Perform the following operations

Perform the following operations:

Battery - Install L Series

Seat - Install L Series