Rear Direction Indicators - Removal

Warning - General - Stabilise Motorcycle

warning
Make sure the motorcycle is stabilised and adequately supported.A correctly supported motorcycle will help prevent it from falling.An unstable motorcycle may fall, causing injury to the operator or damage to the motorcycle.

Perform the following operations

Perform the following operations:

Seat - Remove L Series

Battery - Remove L Series

Rear Indicator Remove LG1; LGX

  1. Remove the rear direction indicator fixings and raise the rear direction indicators and support moulding as an assembly.
    2. Rear Indicator LG1 (cktr_2)

    1. Rear direction indicator (right hand side shown)

    2. Fixing

    3. Support bracket (right hand side shown)

  2. Disconnect the rear licence plate light electrical connector. Unclip and move the connector holder to gain access to the direction indicator connectors.
  3. Noting the position and routing of the wiring, disconnect both direction indicator connectors and remove the direction indicators and support brackets from the support moulding.
    4. Rear Indicator Connectors LG1 (cktq_1)

    1. Left rear direction indicator

    2. Left rear direction indicator connectors

    3. Rear licence plate light

    4. Rear licence plate light connector

    5. Right rear direction indicator

    6. Right rear direction indicator fixings

    7. Rear licence plate light fixings

    8. Left hand support bracket

    9. Right hand support bracket