Rear Direction Indicators - Installation

Warning - General - Stabilise Motorcycle

warning
Make sure the motorcycle is stabilised and adequately supported.A correctly supported motorcycle will help prevent it from falling.An unstable motorcycle may fall, causing injury to the operator or damage to the motorcycle.

Rear Indicator Install LG1; LGX

  1. Position the direction indicators and support brackets to the support moulding and reconnect the electrical connectors as noted during removal.
  2. Reconnect the rear licence plate light connector and reposition the connector holder as noted during removal.
    3. Rear Indicator Connectors LG1 (cktq_1)

    1. Left rear direction indicator

    2. Left rear direction indicator connectors

    3. Rear licence plate light

    4. Rear licence plate light connector

    5. Right rear direction indicator

    6. Right rear direction indicator fixings

    7. Rear licence plate light fixings

    8. Left hand support bracket

    9. Right hand support bracket

  3. Install the support moulding and direction indicators to the rear mudguard and secure with two fixings. Tighten to 3 Nm.
    4. Rear Indicator LG1 (cktr_2)

    1. Rear direction indicator (right hand side shown)

    2. Fixing

    3. Support bracket (right hand side shown)

Perform the following operations

Perform the following operations:

Battery - Install L Series

Seat - Install L Series

  • Check the operation of the rear indicators and the licence plate light. Rectify if necessary.