Purge Control Valve - Installation

Warning - General - Stabilise Motorcycle

warning
Make sure the motorcycle is stabilised and adequately supported.A correctly supported motorcycle will help prevent it from falling.An unstable motorcycle may fall, causing injury to the operator or damage to the motorcycle.

Caution - Transition Pieces, Map/ Evap Hoses - DO NOT Use Lubricants When Fitting

caution
Never use lubricants when fitting throttle bodies onto transition pieces, evaporative hoses (EVAP) or manifold absolute pressure hoses (MAP) on to spigots.When dried, the lubricant may block spigots and/or restrictors. A blocked spigot and/or restrictor will cause the engine to operate inefficiently, and a DTC (diagnostic trouble code) to be recorded.

Purge Valve Install LG1; LGX

  1. If required, position the purge control valve to its mounting bracket ensuring that the locating tab locates correctly into the bracket. Secure with the fixing and tighten to 3 Nm.
  2. Position the purge control valve and mounting bracket to the inlet manifold. Secure with the fixing and tighten to 8 Nm.
  3. Connect the hoses as noted during removal.
  4. Connect the purge control valve electrical connector as noted during removal.
    5. Purge Valve_1 (ckvw)

    1. Purge control valve electrical connector

    2. Purge control valve

    3. Bracket fixing

    4. Hoses

Perform the following operations

Perform the following operations:

Side Panels - Install LG1; LGX

Battery - Install L Series

Seat - Install L Series