Evaporative Canister - Installation

Warning - General - Fuel

warning

Observe the warning advice given in the General Information section on the safe handling of fuel and fuel containers. A fire, causing personal injury and damage to property could result from spilled fuel or fuel not handled or stored correctly.

Caution - Transition Pieces, Map/ Evap Hoses - DO NOT Use Lubricants When Fitting

caution

Never use lubricants when fitting throttle bodies onto transition pieces, evaporative hoses (EVAP) or manifold absolute pressure hoses (MAP) on to spigots.When dried, the lubricant may block spigots and/or restrictors. A blocked spigot and/or restrictor will cause the engine to operate inefficiently, and a DTC (diagnostic trouble code) to be recorded.

Warning - General - Stabilise Motorcycle

warning

Make sure the motorcycle is stabilised and adequately supported.A correctly supported motorcycle will help prevent it from falling.An unstable motorcycle may fall, causing injury to the operator or damage to the motorcycle.

EVAP Canister Install LG1; LGX

If required, route the drain hose as noted during removal.
Make sure the purge valve hose is routed as noted during removal.
Refit the evaporative canister to the bracket, aligning the spigot to the grommet. Secure the canister to the frame with a new cable tie.
Refit the purge valve hose and drain hose to the evaporative canister.