Clutch Cable - Removal

Warning - General - Stabilise Motorcycle

warning
Make sure the motorcycle is stabilised and adequately supported.A correctly supported motorcycle will help prevent it from falling.An unstable motorcycle may fall, causing injury to the operator or damage to the motorcycle.

Perform the following operations

Perform the following operations:

Seat - Remove L Series

Battery - Remove L Series

Clutch Cable Remove LG1

    note
    Note the routing of the clutch cable and the position of the retaining clips/grommets for installation.
  1. Detach the clutch cable retaining clip from the right hand headstock gusset.
  2. Loosen the cable lock nut and release the adjuster at the clutch cover end to give maximum play in the cable.
    3. Clutch Cable Adjuster (chur_2)

    1. Clutch cable

    2. Adjuster

  3. Release the clutch cable from the actuating arm by pushing the inner cable nipple through the arm and sliding the cable out of the slot. Detach the cable from the bracket.
    4. Cable Clutch end LG1

    1. Actuating arm

    2. Inner cable nipple

  4. Align the cable adjuster and lever bracket slots.
  5. Pull in the clutch lever and turn the inner cable, anticlockwise through the slots in the adjuster and lock nut, until the cable can be detached from the lever by pushing downwards.
    6. Detach clutch cable lever end (L0336_1)

    1. Cable adjuster/lever bracket slots

    2. Cable release point

  6. Detach the two grommets from the radiator brackets and remove the clutch cable, noting the routing through the instruments bracket.
    7. Clutch Cable Rad LG1

    1. Grommets

    2. Clutch cable