Battery Tray - Installation

Warning - General - Stabilise Motorcycle

warning
Make sure the motorcycle is stabilised and adequately supported.A correctly supported motorcycle will help prevent it from falling.An unstable motorcycle may fall, causing injury to the operator or damage to the motorcycle.

Battery Tray Install LG1:LGX

  1. Align the battery tray to the frame and alternator regulator/rectifier bracket and position the harness as noted during removal.
  2. Secure the battery tray to the alternator regulator/rectifier bracket with two fixings. Tighten to 5 Nm.
    3. Battery Tray Front Fixings_1 (ckws)

    Some parts removed for clarity

    1. Fixings

    2. Battery tray

    3. Alternator regulator/rectifier bracket

  3. Locate the seat lock cable to the battery tray and position the harness as noted during removal.
  4. Install the two centre fixings and the rear fixing and washer to the battery tray. Tighten to 3 Nm.
  5. Install two new side fixings and tighten to 4 Nm.
  6. Install the engine ECM and reconnect the three electrical connectors.
  7. Reclip the accessory USB connector to the engine ECM tray.
  8. Refit the engine ECM tray with two fixings and tighten to 5 Nm.
    9. LG1 Battery Tray_1 (ckxg)

    Harness not shown for clarity

    1. Engine ECM tray

    2. Rear fixing

    3. Centre fixings

    4. Engine ECM tray fixings

    5. Side fixings

    6. Battery tray

  9. Refit the fuse box to the engine ECM tray.
  10. Refit the relay blocks to the engine ECM tray in the positions as noted during removal.
  11. Reconnect the fall detection switch electrical connector.
  12. Refit the starter solenoid to the battery tray.
  13. Reclip the alarm and rear light connectors to the battery tray.
  14. Refit the ambient air pressure sensor to the battery tray and tighten the fixing to 3 Nm.
LG1 Underseat_1 (ckxh)

  1. Accessory USB connector

  2. Relays

  3. Ambient air pressure sensor

  4. Rear light connector

  5. Alarm connector

  6. Fuse box

  7. Fall detection switch

  8. Starter solenoid

Perform the following operations

Perform the following operations:

Rear Panels Install L Series

Rear Light - Installation LG1; LGX; LL1

Airbox - Install L Series

Fuel Tank - Install L Series

Side Panels - Install LG1; LGX

Battery - Install L Series

Seat - Install L Series