Upper Yoke - Installation

Warning - General - Stabilise Motorcycle

warning
Make sure the motorcycle is stabilised and adequately supported.A correctly supported motorcycle will help prevent it from falling.An unstable motorcycle may fall, causing injury to the operator or damage to the motorcycle.

Upper yoke install LG1; LGX

  1. If required, refit the instruments bracket to the upper yoke with four fixings and tighten to 3 Nm.
  2. Refit the upper yoke and tighten the upper yoke centre nut to 90 Nm.
  3. Tighten the upper yoke pinch bolts, upper fixings first, to 26 Nm.
  4. Locate the handlebar assembly in the upper yoke. Fit the handlebar clamp and bolts.
  5. Align the handlebar alignment mark with the front split line of the left hand side.
  6. Tighten the front clamp bolts to 26 Nm, then the rears.
    7. LG1 Handlebar Align

    1. Alignment mark

    2. Split line (left hand side)

  7. Reroute the harnesses through the upper yoke wire guides as noted during removal.

Perform the following operations

Perform the following operations:

Clutch Cable - Install L Series

Instruments - Install - LG1; LGX; LL1

Battery - Install L Series

Seat - Install L Series