Swinging Arm - Installation

Warning - General - Stabilise Motorcycle

warning
Make sure the motorcycle is stabilised and adequately supported.A correctly supported motorcycle will help prevent it from falling.An unstable motorcycle may fall, causing injury to the operator or damage to the motorcycle.
caution
Care must be taken when positioning the swinging arm, not to damage any brake hoses or electrical harnesses that are routed in close proximity to the swinging arm.

Swinging Arm Install LG1; LGX

  1. Position the swinging arm to the frame ensuring the drive chain is in position on the rubbing strip.
  2. Refit the swinging arm spindle from the right hand side such that it will support the swinging arm, but not pass all the way through the frame adjuster sleeve. This will allow service tool T3880104 to engage in the slot in the frame adjuster sleeve.
  3. Using service tool T3880104, tighten the frame adjuster sleeve to 6 Nm.
    4. Swing Arm Adjuster_1 (ckwz)

    1. Frame adjuster

    2. T3880104 - Swinging Arm Adjuster Wrench

  4. Fully insert the swinging arm spindle.
  5. Fit the washer and a new lock nut and tighten to 110 Nm.
  6. Refit the swinging arm pivot covers.
  7. Route the harness to the swinging arm as noted during removal.
  8. Refit the conduit with the two fir tree clips and fit two new cable ties.
    9. Swinging Arm LH Side_1 (ckxc)

    1. Fir tree clips

    2. Harness conduit

    3. Harness

    4. Cable ties

Perform the following operations

Perform the following operations:

Drag and Drop Links - Installation L Series

RSU Install L Series

Exhaust - Installation L Series

Rear Mudguard - Installation LG1; LGX

Rear Wheel - Install L Series