P0315, P0335 - Crankshaft Position Not Adapted
P0315, P0335 - Crankshaft Position Not Adapted - Fault - LG1; LGX; LL1
Fault Code | Possible cause | Action |
|---|---|---|
P0315 | Crankshaft position not adapted. | |
P0335 | Crankshaft sensor circuit malfunction | View and note diagnostic software freeze frame data if available Ensure sensor is fitted correctly and connector is secure Disconnect Engine ECM and proceed to pinpoint test 1 |
Subheading - Pinpoint Test
Pinpoint Tests
P0315, P0335 - Crankshaft Position Not Adapted - Pinpoint test - HG8; HJ8; HK8; HL8; LG1; LGX; LJ2; LK2; LL1
Test | Result | Action | |
|---|---|---|---|
1 | Check terminal and cable integrity: - Engine ECM pin B17 - Engine ECM pin B16 | OK | Disconnect sensor and proceed to test 2 |
Faulty | Rectify fault, proceed to test 6 | ||
2 | Check cable for short circuit: - Engine ECM pin B17 to ground - Engine ECM pin B16 to ground | OK | Proceed to test 3 |
Short circuit | Locate and rectify wiring fault, proceed to test 6 | ||
3 | Check cable continuity: - Engine ECM pin B16 to sensor pin 2 - Engine ECM pin B17 to sensor pin 1 | OK | Proceed to test 4 |
Open circuit | Locate and rectify wiring fault, proceed to test 6 | ||
4 | Check cable for short circuit: - Engine ECM pin B17 to Engine ECM pin B16 | OK | Renew crankshaft sensor, proceed to test 6 |
Short circuit | Locate and rectify wiring fault, proceed to test 6 | ||
5 | Check crank toothed wheel: - Damage to teeth - magnetic debris contamination | OK | Proceed to test 6 |
Faulty | Clean/renew toothed wheel, proceed to test 6 | ||
6 | Reconnect harness, clear fault code and run engine to verify fault cleared. | OK | Action complete - quit test |
Fault still present | Contact Triumph service | ||
Subheading - Circuit Diagram
Circuit Diagram
P0315, P0335 - Crankshaft Position Not Adapted - Circuit Diagram - LG1; LGX
|