Front ABS Wheel Speed Sensor - Installation

Warning - General - Stabilise Motorcycle

warning
Make sure the motorcycle is stabilised and adequately supported.A correctly supported motorcycle will help prevent it from falling.An unstable motorcycle may fall, causing injury to the operator or damage to the motorcycle.
note
Check the condition of the shim before use. Do not use a shim which is bent or damaged.

FWSS Install LG1; LGX

  1. Position the wheel speed sensor to the fork leg with its shim between the sensor and fork leg. Tighten the fixing to 9 Nm.
    2. Front WSS_1 (ckxf)

    1. Front ABS wheel speed sensor

    2. Fixing

  2. Route the sensor harness along the front brake hose as noted for removal. Secure with the three clips.
  3. Route the sensor harness through the wire guide behind the lower yoke and through the frame as noted during removal.
  4. Connect the wheel speed sensor multiplug and secure the harness to the clip behind the bracket. Any slack in the harness must be positioned behind the headstock area.
    5. Front Wheel Speed Sensor Connection LG1 (ckum_1)

    1. Front wheel speed sensor multiplug

  5. Install the fuel tank bodywork (see Fuel Tank - Installation)

Perform the following operations

Perform the following operations:

Battery - Install L Series

Seat - Install L Series