Front ABS Wheel Speed Sensor - Removal

Warning - General - Stabilise Motorcycle

warning
Make sure the motorcycle is stabilised and adequately supported.A correctly supported motorcycle will help prevent it from falling.An unstable motorcycle may fall, causing injury to the operator or damage to the motorcycle.

Perform the following operations

Perform the following operations:

Seat - Remove L Series

Battery - Remove L Series

FWSS Remove LG1; LGX

note
Note the routing of the front ABS wheel speed sensor harness and its retaining clips for installation.The front ABS wheel speed sensor multiplug is identified as the white connector located next to the immobiliser module.
  1. Disconnect the front ABS wheel speed sensor multiplug.
    2. Front Wheel Speed Sensor Connection LG1 (ckum_1)

    1. Front wheel speed sensor multiplug

  2. Detach the wheel speed sensor harness from its three clips on the front brake hose and the wire guide behind the lower yoke.
  3. Release the fixing and remove the sensor. Collect the shim from between the sensor and fork leg.
    4. Front WSS_1 (ckxf)

    1. Front ABS wheel speed sensor

    2. Fixing