Rear ABS Wheel Speed Sensor - Removal

Warning - General - Stabilise Motorcycle

warning
Make sure the motorcycle is stabilised and adequately supported.A correctly supported motorcycle will help prevent it from falling.An unstable motorcycle may fall, causing injury to the operator or damage to the motorcycle.

Perform the following operations

Perform the following operations:

Seat - Remove L Series

Battery - Remove L Series

RWSS Remove - LG1; LGX

    note
    Note the routing of the harness and its retaining clips for installation.
  1. Remove the fixing and remove the rear wheel speed sensor and bracket and position to one side, noting the routing for installation. Collect the shim from in between the sensor and the caliper carrier.
  2. Release the harness from the three clips and two wire guides.
    3. Swingarm RH Side_1 (ckxa)

    1. Rear wheel speed sensor

    2. Bracket

    3. Fixing

    4. Clips

    5. Wire guide

    Swingarm RH Side_2 (ckxb)

    1. Clips

    2. Wire guides

    3. Swinging arm

  3. Detach the rear ABS wheel speed sensor multiplug from its bracket on the battery tray and disconnect from the main harness.