Rear ABS Wheel Speed Sensor - Installation

Warning - General - Stabilise Motorcycle

warning
Make sure the motorcycle is stabilised and adequately supported.A correctly supported motorcycle will help prevent it from falling.An unstable motorcycle may fall, causing injury to the operator or damage to the motorcycle.
note
Check the condition of the shim before use. Do not use a shim which is bent or damaged.

RWSS Install LG1; LGX

  1. Refit the rear wheel speed sensor, shim and bracket with the fixing, routing the harness through the two wire guides and three clips as noted during removal. Tighten the fixing to 9 Nm.
    2. Swingarm RH Side_1 (ckxa)

    1. Rear wheel speed sensor

    2. Bracket

    3. Fixing

    4. Clips

    5. Wire guide

    Swingarm RH Side_2 (ckxb)

    1. Clips

    2. Wire guides

    3. Swinging arm

  2. Connect the wheel speed sensor multiplug and secure to its bracket on the battery tray.
  3. Refit the right hand side panel (see Side Panels - Installation)

Perform the following operations

Perform the following operations:

Battery - Install L Series

Seat - Install L Series