Rear Sprocket - Installation

Caution - Wheels - Do not rest on brake disc

caution
Do not allow the wheel to rest on the brake disc, as this may damage the disc. Support the wheel on wooden blocks, equally spaced around the rim, such that the brake disc is raised above the ground.
  1. If necessary, replace any rear sprocket studs that have been loosened or removed as follows:
    2. * Remove and discard any of the studs that have become loose.
    * Fit new studs and tighten to 30 Nm.
    Rear sprocket stud height Stud height_1

    1. Studs (three of six shown)

  2. Fit the rear sprocket to the sprocket carrier as noted for removal.
  3. Fit new lock nuts, evenly and progressively tighten to 55 Nm.

Perform the following operations

Perform the following operations:

Rear Wheel - Install L Series