Gear Change Linkage - Removal

Warning - General - Stabilise Motorcycle

warning
Make sure the motorcycle is stabilised and adequately supported.A correctly supported motorcycle will help prevent it from falling.An unstable motorcycle may fall, causing injury to the operator or damage to the motorcycle.
note
If the gear change linkage requires disassembly, continue from step one. If the gear change linkage requires removal only, continue from step three.
  1. Remove the wire clips retaining the gear change linkage upper and lower ball joints.
    2. Wire clip install to gear linkage T0550

    1. Ball joint

    2. Wire clip

  2. Remove the gear change linkage.
  3. Remove the gear change clamp fixing.
    4. LG1 Gear Change Clamp_1

    1. Gear change clamp

    2. Fixing

  4. Remove and discard the gear change pivot bolt.
    5. Gear Change Pivot LG1 (ckyo)

    1. Gear change pivot bolt

    2. Gear change pedal

  5. Remove the gear change pedal and gear change clamp from the motorcycle, noting the position of the gear change clamp for installation.