Starter Motor - Removal

Warning - General - Stabilise Motorcycle

warning
Make sure the motorcycle is stabilised and adequately supported.A correctly supported motorcycle will help prevent it from falling.An unstable motorcycle may fall, causing injury to the operator or damage to the motorcycle.

Perform the following operations

Perform the following operations:

Seat - Remove L Series

Battery - Remove L Series

Fuel Tank - Remove L Series

Airbox - Remove L Series

Coolant Expansion Tank - Removal L Series

Purge Valve - Remove L Series

Throttle Body - Remove L Series

Inlet Manifold - Removal - LG1; LG2; LGX; LH2; LL1

  1. Disconnect the low oil pressure warning light switch.
  2. Ease the boot from the starter cable terminal and then release the cable bolt.
  3. Detach the cable from the starter motor.
    4. note
    Note the position of the mounting bracket for the crankshaft position sensor multiplug for installation.
  4. Release the fixings securing the starter to the crankcase.
    5. Starter motor fixings ciah

    1. Fixings

    2. Starter motor

    3. Multiplug, crankshaft position sensor

  5. Ease the starter motor from the upper crankcase.