Starter Motor - Installation

  1. Fit a new O-ring to the starter motor.
  2. Lubricate the starter motor O-ring with a small amount of petroleum jelly.
  3. Fit the starter motor to the upper crankcase with the multiplug for the crankshaft position sensor as noted for removal. Ensure that the O-ring does not become damaged during installation.
    4. Starter motor fixings ciah

    1. Fixings

    2. Starter motor

    3. Multiplug, crankshaft position sensor

  4. Fit and tighten the starter motor bolts to 10 Nm.
  5. Refit the starter cable and secure with the bolt. Tighten to 3 Nm.
  6. Refit the starter cable boot.
  7. Connect the low oil pressure warning light switch.

Perform the following operations

Perform the following operations:

Inlet Manifold - Install - LG1; LGX; LL1

Throttle Body - Install L Series

Purge Valve - Install L Series

Coolant Expansion Tank - Installation L Series

Airbox - Install L Series

Fuel Tank - Install L Series

Battery - Install L Series

Seat - Install L Series