Coolant Expansion Tank - Installation

Warning - General - Stabilise Motorcycle Including locking devices

Warning - General - Stabilise Motorcycle - including DO NOT support on non integral parts

warning
Make sure the motorcycle is stabilised and adequately supported.Do not support the motorcycle on any ancillary component, the exhaust system or any other non structural parts of the motorcycle frame.A correctly supported motorcycle will help prevent it from falling.Failure to follow the advice above could result in serious injury or death.

Note to be used in service manual with stabilise warning

notice
Renew locking devices where specified, refer to Fixings.Before tightening a fixing using a crow foot spanner adapter, refer to Use of Crow Foot Spanner Adapters with Torque Wrenches.Observe all torque wrench tightening procedures, refer to Tightening Procedures.

Expansion Tank Install - LG1; LGX; LL1

  1. Position the coolant expansion tank onto the frame and brackets.
  2. Refit the cover and secure the tank and cover with three fixings and washers. Tighten to 3 Nm.
    3. Coolant Expansion Tank LG1

    1. Coolant expansion tank cap

    2. Coolant expansion tank

    3. Fixings

  3. Check and adjust the coolant level as necessary (see Coolant Level Inspection and Coolant Level Adjustment).
  4. Refit the coolant expansion tank cap.