Alternator Stator - Installation

Warning - General - Stabilise Motorcycle

warning
Make sure the motorcycle is stabilised and adequately supported.A correctly supported motorcycle will help prevent it from falling.An unstable motorcycle may fall, causing injury to the operator or damage to the motorcycle.
  1. Locate the stator and crankshaft position sensor to the engine cover.
  2. Apply silicone sealer to the cable grommet (at the factory, ThreeBond 1215 is used) and align the cable to the exit slot.
  3. Fit the cable retainer bracket and tighten the new fixings to 6 Nm.
  4. Tighten the alternator stator new fixings to 12 Nm.
  5. Tighten the crankshaft position sensor new fixings to 6 Nm.
  6. Alt Stator LG1_1 (ckxv)
    1. Fixings

    2. Crankshaft position sensor

    3. Cable bracket

    4. Alternator stator

Perform the following operations

Perform the following operations:

Alternator Cover - Install L Series