Side Stand Switch - Removal

Warning - General - Stabilise Motorcycle

warning
Make sure the motorcycle is stabilised and adequately supported.A correctly supported motorcycle will help prevent it from falling.An unstable motorcycle may fall, causing injury to the operator or damage to the motorcycle.

Perform the following operations

Perform the following operations:

Seat - Remove L Series

Battery - Remove L Series

Coolant Expansion Tank - Removal L Series

Side Stand Switch Remove LG1; LGX; LJ2; LK2

    caution
    Note the routing and the retaining clips of the side stand switch harness for installation.
  1. Disconnect the side stand switch electrical connector from the engine sub harness at the rear of the starter motor and feed it down to the side stand switch.
    2. Side stand switch connector LG1 (T3443_1)

    1. Side stand switch electrical connector

    2. Side stand switch harness

  2. Release the fixings and remove the gear change bracket from the frame.
  3. Release the fixings and remove the side stand switch from the gear change bracket. Discard the fixings.
    4. Gear Change Bracket LG1

    1. Gear change bracket

    2. Fixings

    3. Side stand switch