Side Stand Switch - Installation

Warning - General - Stabilise Motorcycle

warning
Make sure the motorcycle is stabilised and adequately supported.A correctly supported motorcycle will help prevent it from falling.An unstable motorcycle may fall, causing injury to the operator or damage to the motorcycle.

Side Stand Switch Install LG1; LGX

  1. Fit the side stand switch to the gear change bracket tighten the new fixings to 7 Nm.
  2. Fit the gear change bracket to the frame and tighten the fixings to 24 Nm.
    3. Gear Change Bracket LG1

    1. Gear change bracket

    2. Fixings

    3. Side stand switch

  3. Route the side stand switch harness and reconnect to the engine sub harness as noted for removal.
    4. Side stand switch connector LG1 (T3443_1)

    1. Side stand switch electrical connector

    2. Side stand switch harness

Perform the following operations

Perform the following operations:

Coolant Expansion Tank - Installation L Series

Battery - Install L Series

Seat - Install L Series