Engine Electronic Control Module (ECM) Installation

Warning - General - Stabilise Motorcycle

warning
Make sure the motorcycle is stabilised and adequately supported.A correctly supported motorcycle will help prevent it from falling.An unstable motorcycle may fall, causing injury to the operator or damage to the motorcycle.

Engine ECM Install LG1; LGX

  1. Install the engine ECM and reconnect the three electrical connectors.
  2. Refit the engine ECM tray with two fixings and tighten to 5 Nm.
    3. LG1 Battery Tray_1 (ckxg)

    Harness not shown for clarity

    1. Engine ECM tray

    2. Rear fixing

    3. Centre fixings

    4. Engine ECM tray fixings

    5. Side fixings

    6. Battery tray

  3. Reroute the harness and seat lock cable over the engine ECM tray as noted during removal.
  4. Reclip the accessory USB connector to the engine ECM tray.
  5. Refit the fuse box to the engine ECM tray.
  6. Refit the relay blocks to the engine ECM tray in the positions as noted during removal.
  7. Reconnect the fall detection switch electrical connector.
  8. Refit the starter solenoid to the battery tray.
  9. Reclip the alarm and rear light connectors to the battery tray.
  10. Refit the ambient air pressure sensor to the battery tray and tighten the fixing to 3 Nm.
    11. LG1 Underseat_1 (ckxh)

    1. Accessory USB connector

    2. Relays

    3. Ambient air pressure sensor

    4. Rear light connector

    5. Alarm connector

    6. Fuse box

    7. Fall detection switch

    8. Starter solenoid

  11. Refit the diagnostic connector to its locating tang.

Perform the following operations

Perform the following operations:

Battery - Install L Series

Seat - Install L Series