Immobiliser Control Module - Installation

Warning - General - Stabilise Motorcycle

warning
Make sure the motorcycle is stabilised and adequately supported.A correctly supported motorcycle will help prevent it from falling.An unstable motorcycle may fall, causing injury to the operator or damage to the motorcycle.

Immobiliser Install LG1; LGX

  1. Route the immobiliser harness through the frame as noted during removal.
  2. Secure the immobiliser with two fixings and tighten to 1.5 Nm.
  3. Reconnect the immobiliser to the main harness.
    4. Immobiliser Connector LG1

    1. Immobiliser electrical connector

    2. ABS modulator

  4. Make sure the two rubber grommets are fitted to the frame and one is fitted to the ABS modulator bracket.
  5. Align the ABS modulator and bracket to the frame and secure with two flanged sleeves and two new fixings. Tighten the fixings to 9 Nm.
    6. ABS Modulator_front fixings_1 (ckus)

    1. Fixings

    2. ABS modulator bracket

  6. Install a flanged sleeve and new fixing and tighten to 9 Nm.
    7. ABS Modulator_1 (ckuq)

    1. ABS modulator

    2. ABS modulator multiplug

    3. ABS modulator rear fixing

    4. Brake line unions

Perform the following operations

Perform the following operations:

Fuel Tank - Install L Series

Battery - Install L Series

Seat - Install L Series