Twist Grip Position Sensor - Installation

Warning - General - Stabilise Motorcycle

warning
Make sure the motorcycle is stabilised and adequately supported.A correctly supported motorcycle will help prevent it from falling.An unstable motorcycle may fall, causing injury to the operator or damage to the motorcycle.

Twist Grip Position Sensor Install LG1; LGX

  1. Slide the twist grip position sensor onto the handlebar in the orientation noted for removal.
  2. Route the twist grip harness to the main harness as noted for removal.
  3. Connect the harness to the main harness then attach the connector to its bracket on the fuel tank.
    4. Twist Grip Position Sensor LG1 (ckyk)

    1. Twist grip position sensor main harness connector

    2. Twist grip position sensor connector

  4. Refit the rubber band around the right hand switch cube harness, right hand side front direction indicator harness and twist grip position sensor harness as noted during removal.

Perform the following operations

Perform the following operations:

Twist Grip - Installation L Series

Fuel Tank Bodywork Install LG1; LGX

Battery - Install L Series

Seat - Install L Series