Intake Air Temperature Sensor - Installation

Warning - General - Stabilise Motorcycle

warning
Make sure the motorcycle is stabilised and adequately supported.A correctly supported motorcycle will help prevent it from falling.An unstable motorcycle may fall, causing injury to the operator or damage to the motorcycle.
note
The intake air temperature sensor harness is identified by red tape.
  1. Check the condition of the rubber washer and replace if necessary.
  2. Make sure the threads of the sensor are clean and apply Threebond 1360.
  3. Install the intake air temperature sensor to the inlet manifold moulding and tighten to 1 Nm.
  4. Refit the harness to the intake air temperature sensor.
    5. Air Temp Sensor LG1 (ckye)

    1. Intake air temperature sensor

    2. Electrical connector

    3. Red tape identifier

Perform the following operations

Perform the following operations:

Battery - Install L Series

Seat - Install L Series