Coolant Temperature Sensor - Removal

Warning - General - Stabilise Motorcycle - including DO NOT support on non integral parts

warning
Make sure the motorcycle is stabilised and adequately supported.Do not support the motorcycle on any ancillary component, the exhaust system or any other non structural parts of the motorcycle frame.A correctly supported motorcycle will help prevent it from falling.An unstable motorcycle may fall resulting in motorcycle damage, serious injury or death.

Perform the following operations

Perform the following operations:

Seat - Remove L Series

Battery - Remove L Series

Fuel Tank - Remove L Series

Airbox - Remove LG1; LG2; LGX; LH2; LL1; LL2

Throttle Body - RemoveLG1; LG2; LGX; LH2; LL1; LL2

Inlet Manifold - Removal - LG1; LG2; LGX; LH2; LL1

Coolant Temperature Sensor Remove - LG1; LGX; LL1

  1. Disconnect the coolant temperature sensor from the main harness, noting its routing in between ignition coil 1 and injector 1 harness connector.
    2. Coolant Temp Sensor Harness LG1_1 (ckyf)

    1. Ignition coil 1

    2. Coolant temperature harness connector

    3. Injector 1 harness connector

  2. Disconnect the bypass hose from the cylinder head spigot.
  3. Remove the rubber cover and using a suitable 19 mm slotted socket, remove the coolant temperature sensor from the cylinder head, noting the routing of the harness for installation.
    4. Coolant Temp Sensor LG1_1 (ckyg)

    1. Bypass hose

    2. Coolant temperature sensor