Coolant Temperature Sensor - Installation

Warning - General - Stabilise Motorcycle

warning
Make sure the motorcycle is stabilised and adequately supported.A correctly supported motorcycle will help prevent it from falling.An unstable motorcycle may fall, causing injury to the operator or damage to the motorcycle.
  1. Fit the coolant temperature sensor into the cylinder head and tighten to 18 Nm and route the harness as noted during removal. Refit the rubber cover.
  2. Refit the bypass hose to the cylinder head spigot.
    3. Coolant Temp Sensor LG1_1 (ckyg)

    1. Bypass hose

    2. Coolant temperature sensor

  3. Reconnect the coolant temperature sensor to the main harness, routing the harness as noted during removal.
    4. Coolant Temp Sensor Harness LG1_1 (ckyf)

    1. Ignition coil 1

    2. Coolant temperature harness connector

    3. Injector 1 harness connector

Perform the following operations

Perform the following operations:

Inlet Manifold - Install - LG1; LGX; LL1

Throttle Body - Install L Series

Airbox - Install L Series

Fuel Tank - Install L Series

Battery - Install L Series

Seat - Install L Series