Gear Change Rod Setting

note
If accessory fit Triumph Shift Assist (TSA) is fitted, the length of the rod should not be altered.

Gear Rod Setting LG1

If the gear change linkage needs to be removed, ensure the setting dimension and alignment are as described below when refitting.

  • Make sure the alignment mark on the gear pedal crank lines up to the alignment mark on the gear change shaft

  • Ensure the distance between the flats of the ball joints is 242.5 mm as shown below.

    • LG1 Gear Change Rod Setting

    Gear change rod setting dimension

  • The length of exposed thread at each end of the gear change rod should be equal.

  • Tighten the gear change rod lock nuts to 6 Nm.

  • Ensure the gear change mechanism is free to operate, without any excessive play.