Starter Drive/Sprag Clutch - Removal

Warning - General - Stabilise Motorcycle

warning
Make sure the motorcycle is stabilised and adequately supported.A correctly supported motorcycle will help prevent it from falling.An unstable motorcycle may fall, causing injury to the operator or damage to the motorcycle.

Perform the following operations

Perform the following operations:

Seat - Remove L Series

Battery - Remove L Series

Alternator Cover - Remove L Series

  1. Withdraw the starter idler gear and shaft, noting the fitted position of the components.
    2. Starter idler gear L0346

    1. Idler gear

    2. Idler shaft

  2. Remove the alternator rotor (see Alternator Rotor - Removal).
  3. Withdraw the starter drive gear from the sprag clutch.
    4. Detach starter drive gear cdnb_1

    1. Starter drive gear

    2. Sprag clutch/housing

    3. Alternator rotor

  4. Remove and discard the fixings securing the sprag clutch housing to the alternator rotor. Withdraw the sprag clutch housing.
  5. Remove the sprag clutch from the housing.
    6. Sprag clutch from housing sprag hub

    1. Sprag clutch housing

    2. Sprag clutch assembly