Oil Pump - Assembly

  1. If all clearances are within service limits, liberally apply clean engine oil to all internal components and refit the oil pump body to the oil pump rotor. Refit the fixings and tighten to 12 Nm.
  2. If any clearance measured is outside the service limits, renew the complete pump.
  3. Inspect the sprockets and chain for wear and/or damage. Replace the sprockets and chain if wear and/or damage is found.
  4. Check the water pump shaft and shaft bearings for side and end float. Renew if necessary.
  5. Check for corrosion and scale build-up around the impeller and in the pump body. Renew if necessary.
  6. Check the oil pump location dowel for damage. Renew if necessary.
  7. Refit the spacer washer and drive sprocket. Apply ThreeBond 1374 to the fixing and tighten to 12 Nm.
Oil Pump, Spacer, Drive Sprocket and Fixing cdpp_5

  1. Oil pump

  2. Spacer washer

  3. Drive sprocket

  4. Fixing