Thermostat - Installation

Warning - General - Stabilise Motorcycle

warning
Make sure the motorcycle is stabilised and adequately supported.A correctly supported motorcycle will help prevent it from falling.An unstable motorcycle may fall, causing injury to the operator or damage to the motorcycle.
  1. Locate the thermostat into the cylinder head. Ensure the bleed valve is uppermost as shown below.
    2. Thermostat LG1

    1. Thermostat

    2. Bleed valve

  2. Fit a new O-ring to the thermostat housing groove.
    3. Thermostat housing O-ring cash

    1. O-ring groove

  3. Refit the thermostat housing and bracket to the cylinder head,
  4. Tighten the fixings to 9 Nm.
    5. Thermostat Fixings LG1

    1. Thermostat housing

    2. Fixings

    3. Coolant expansion tank bracket

  5. Reconnect the top hose. Ensure the hose clip is positioned as noted for removal.

Perform the following operations

Perform the following operations:

Coolant Expansion Tank - Installation L Series

Inlet Manifold - Install - LG1; LGX; LL1

Throttle Body - Install L Series

Airbox - Install L Series

Fuel Tank - Install L Series

Battery - Install L Series

Seat - Install L Series