Balancer Cover - Installation

Warning - General - Stabilise Motorcycle Including locking devices

Warning - General - Stabilise Motorcycle - including DO NOT support on non integral parts

warning
Make sure the motorcycle is stabilised and adequately supported.Do not support the motorcycle on any ancillary component, the exhaust system or any other non structural parts of the motorcycle frame.A correctly supported motorcycle will help prevent it from falling.Failure to follow the advice above could result in serious injury or death.

Note to be used in service manual with stabilise warning

notice
Renew locking devices where specified, refer to Fixings.Before tightening a fixing using a crow foot spanner adapter, refer to Use of Crow Foot Spanner Adapters with Torque Wrenches.Observe all torque wrench tightening procedures, refer to Tightening Procedures.

Balancer Cover Install LG1; LG2; LGX; LH2; LL2

  1. Fit a new gasket to the balancer cover.
  2. Fit the balancer cover and tighten its fixings to 8 Nm in the sequence shown below.
  3. Re-tighten the fixings one and two to 8 Nm.
    4. Balancer Cover Sequence (ckux_2)

    Balancer Cover Fixings Tightening Sequence