ABS Warning Light ON (No DTCs Stored)
ABS Warning Light ON (No DTCs Stored) - Fault - CM8; CR8; CS8; HF8; HG8; HJ8; HK8; HL8; LG1; LGX; LJ2; LK2; LL1; PB1; PJ1; PJZ; PM1; PR1; PRC; PS1; PSC; PX1; PXC; PY1; PYC
Fault Code | Possible cause | Action |
|---|---|---|
ABS Warning Light ON (No DTCs Stored) | ABS Ignition supply fuse/circuit fault ABS Warning light circuit fault | Ensure ABS ECM connector is secure. Disconnect ABS ECM connector and proceed to pinpoint test 1: |
Subheading - Pinpoint Test
Pinpoint Tests
ABS Warning Light ON (No DTCs Stored) - Pinpoint Test -LG1; LGX; LL1
Test | Result | Action | |
|---|---|---|---|
1 | Check cable and terminal integrity: - ABS ECM connector pin 7 and ground pin 10 | OK | Proceed to test 2 |
Faulty | Rectify fault, proceed to test 5 | ||
2 | Check cable continuity of the ABS ignition supply circuit: With the ignition 'ON', check voltage between: - ABS ECM connector pin 7 and ground pin 10 | Voltage greater than 10 V | Proceed to test 3 |
Voltage less than 10 V | Locate and rectify wiring fault, proceed to test 5 | ||
3 | Check cable continuity of the ABS warning light circuit: Reconnect the ABS ECM connector Check voltage between: - ABS ECM connector pin 3 and ground pin 10 Disconnect the ABS ECM connector | Voltage greater than 1.5 V | Proceed to test 4 |
Voltage less than 1.5 V | Locate and rectify fault, proceed to test 5 | ||
4 | Check cable continuity of the ABS warning light circuit: - Short ABS ECM connector pin 3 and ground pin 10 together: Turn ignition 'ON' | ABS warning light 'OFF' | Proceed to test 5 |
ABS warning light 'ON' | Locate and rectify fault, proceed to test 5 | ||
5 | Reconnect ABS ECM harness, clear fault code and test ABS to verify fault cleared. | OK | Action complete - quit test |
Fault still present | Contact Triumph service | ||
Subheading - Circuit Diagram
Circuit Diagram
ABS Warning Light ON (No DTCs Stored) - Circuit Diagram - LG1; LGX
|