Final Drive Chain Guard - Installation

Warning - General - Stabilise Motorcycle Including locking devices

Warning - General - Stabilise Motorcycle - including DO NOT support on non integral parts

warning
Make sure the motorcycle is stabilised and adequately supported.Do not support the motorcycle on any ancillary component, the exhaust system or any other non structural parts of the motorcycle frame.A correctly supported motorcycle will help prevent it from falling.Failure to follow the advice above could result in serious injury or death.

Note to be used in service manual with stabilise warning

notice
Renew locking devices where specified, refer to Fixings.Before tightening a fixing using a crow foot spanner adapter, refer to Use of Crow Foot Spanner Adapters with Torque Wrenches.Observe all torque wrench tightening procedures, refer to Tightening Procedures.
  1. Position the two locating slots at the front end of the rear hugger and chain guard onto the retaining grommets.
  2. Make sure the two retaining tangs on the rear suspension unit guard are in the locating holes on the rear hugger and chain guard.
  3. Fit the two fixings and tighten to 4 Nm.
    4. Final Drive Chain Guard_TP0416

    1. Rear hugger and chain guard

    2. Fixing (left hand side)

    3. Fixing location (right hand side)

    4. Retaining tangs

    5. Retaining grommet (left hand side)